Tube Bait - 1 1/2" - 12 cavity mold.
The bodies are 1/4" diameter. The center opening is 1/8" diameter and 1 13/32" long from the tail end. The molded plastic thickness at the front of the bait is 3/32".

These baits can be used with in-body tube jigs.

To use this mold, lay the mold on its side with the screws facing up. Insert the pins into the holes, flush with the bottom. Turn the mold upright and tighten the screws and inject. The pins may fall out if the mold is lifted before injecting.

Applying a small amount of worm oil to the pins will help the plastic to flow around the pins and the pins need to be warmed. The plastic will cool and solidify before filling the cavities completely if the pins are cold.

The tails stands are not molded! They are sliced after injected with razor blades.

To use this mold, lay the mold on its side with the screws facing up. Insert the pins into the holes, flush with the bottom. Turn the mold upright and tighten the screws and inject. The pins may fall out if the mold is lifted before injecting.

Applying a small amount of worm oil to the pins will help the plastic to flow around the pins and the pins need to be warmed. The plastic will cool and solidify before filling the cavities completely if the pins are cold.