1 1/2" Twister Tail Bait - 8 cavity
This is an aluminum CNC machined, 2 piece, 8 cavity, hand injection mold.
This bait is molded at 1 1/8" inch length, and stretches out to 1 1/2" in the water.
The body diameter is 3/16"
This mold is a single shot design which fill all 8 cavities simultaneously.
Posted by Andre From Lake Champlain,New York.. on 20th Aug 2015
This mold injects very quickly and with NO flashing.The is a great pan-fish bait.It should also do very well thru the ice...The only thing I'm not crazy about is the 2 screws needed to hold the two half's together.If you know guys are going to use clamps on them why drill and tap the holes?? SWEET BAIT is the bottom line here..Great Job Jacobs Molds..
Posted by Andre From Lake Champlain, New York on 8th May 2015
I would have give it a 5 star rating but I don't like the screws to close the mold..I don't they should leave to the customer to figure out how to properly clamp the mold..Other than that great product..
Posted by JR on 31st Mar 2015
Nice mold, only downfall is it uses screws to clamp it so you have to keep a screw driver handy, adds a few minutes on the molding process